ADTRAN 600R - Manual (Page 177)

Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 175
T1 Interface Setup Instructions
Step Action
1 From the main menu, select I NTERFACES .
2 Highlight the C ONFIG menu for the T1 interface and press <E NTER >.
3 Right arrow to select F ORMAT and choose ESF or SF.
This format must match the format used by the other units in the network.
4 Set the L INE C ODE to B8ZS or AMI.
This line code must match the line code used by the other units in the network.
5
Set the E QUALIZATION or line build out. The default setting of 0 D B is usually
sufficient.
6
Set the CSU L PBK option to E NABLE , D ISABLE , or D ISABLE A LL based on
whether looping to this unit from another unit will be allowed.
Ethernet Interface Setup Instructions
Most applications should not require a manual setup for the Ethernet interface. By
default, the Ethernet interface is configured to auto-detect the data rate (as either 10
or 100 Mbps). The following steps disable the auto-negotiation parameter and
manually configure the interface.
Step Action
1 From the main menu, select I NTERFACES .
2 Highlight the C ONFIG menu for the ETH interface and press <E NTER >.
3
Use the right arrow to select A UTONEGOTIATION and press <E NTER >. Use the
down arrow to choose OFF.
4 Select the D ATA R ATE field and specify either 10B ASE T or 100B ASE T.
5 Select the D UPLEX T YPE field and specify either H ALF D UPLEX or F ULL D UPLEX .