ADTRAN 600R User Manual
Page 71
Total Access 600 Series System Manual
Section 4 User Interface Guide
61200624L1-1B
© 2004 ADTRAN, Inc.
69
S
YSTEM
U
TILITY
> T
RACEROUTE
> T
RACE
T
ARGET
Specifies the IP address of the remote system to trace the routes to.
S
YSTEM
U
TILITY
> T
RACEROUTE
> M
AXIMUM
H
OPS
Specifies the maximum number of router exchanges allowed when traveling to the final destination
(specified using the
T
RACE
T
ARGET
field) Range is
1
to
30
. Default is
30
.
S
YSTEM
U
TILITY
> T
RACEROUTE
> T
IMEOUT
(
IN
SECS
)
Specifies the maximum delay (in seconds) given to a host (along a path to the final destination) to respond
to the probe datagram sent before considering the packet a failure.
S
YSTEM
U
TILITY
> T
RACEROUTE
> R
ETRIES
Specifies the number of times the probe datagram is sent to each host (along the path to the final
destination).
S
YSTEM
U
TILITY
> T
RACEROUTE
> B
EGIN
T
RACEROUTE
Activates the traceroute process.
S
YSTEM
U
TILITY
> R
ESET
U
NIT
Selecting this activator will initiate a soft reset of the unit.
S
YSTEM
U
TILITY
> T
ERMINAL
M
ODE
Selecting the terminal mode gives the user a command-line prompt to perform utilities such as pings,
traceroutes, resets, firmware updates, configuration, and more.
T
ERMINAL
M
ODE
can also be accessed by
using the shortcut keys <Ctrl+T> from other menu screens. From this command-line prompt, you can:
•
Perform a reset with the command "reset"
•
Perform a complete factory restore with the command "factory_reset"
•
Configure the unit. The unit has the ability to download a text file which contains the configuration of
the entire unit. This configuration may then be altered in a text editor, and then uploaded to a unit. (See
DLP-13, Saving and Loading Text Configuration using Terminal Command Line, for further
assistance.)
•
Debug and troubleshoot. This function would be carried out with the assistance of ADTRAN Technical
Support.
•
Start and stop the fail-safe timer for the auto-config feature.
•
Perform a firmware upgrade via TFTP.
upgrade_firmware hostname filename
•
Use the save command to write the entire configuration to flash.
•
Display the unit’s MAC address with the command mac.
•
Perform a ping or extended ping. Syntax is:
ping hostname/address [repeat xx] [size xx] [timeout xx] [source xx] [noNat]