ADTRAN 600R - Manual (Page 184)

Section 4 User Interface Guide Total Access 600 Series System Manual
182 © 2004 ADTRAN, Inc. 61200624L1-1B
3. Verifying the Bridge Options
For more details on the configuration parameters discussed in this section, refer to the following pages:
Bridge menus beginning on page 117
9
Set mode to R OUTE IP. Using this menu you also have the option to route only
IP packets and bridge all other data packets (R OUTE IP/B RIDGE O THER ) or
bridge all data packets on this connection (B RIDGE A LL ). Refer to L2 Protocol
(ATM–NET–ATM) > Config > PVC Config > Setup (Router) on page 103 for
more details.
10 Left arrow back to the main menu to save the changes.
Bridge Options
Step Action
1 From the main menu, select B RIDGE and press <E NTER >.
2 Use the right arrow key to highlight C ONFIG and press <E NTER >.
3
Select I NTERFACES and press <E NTER >. Verify that the desired interface is
listed in this table.
4 Left arrow back to the B RIDGE > C ONFIG menu.
5
Select B RIDGE T ABLE and set the B RIDGE T ABLE A GING to the desired time (in
minutes) it takes an entry to age out of the Bridge table.
6 Left arrow back to the main menu to save the changes.
Layer 2 Protocol (ATM) Configuration – T1 Interface (Continued)