ADTRAN 600R - Manual (Page 169)

Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 167
2. Mapping the DS0s
For more details on the configuration parameters discussed in this section, refer to the following pages:
DS0 Map menus beginning on page 149
This line code must match the line code used by the other units in the network.
5
Set the E QUALIZATION or line build out. The default setting of 0 D B is usually
sufficient.
6
Set the CSU L PBK option to E NABLE , D ISABLE , or D ISABLE A LL based on
whether looping to this unit from another unit will be allowed.
DSX-1 Interface Setup Instructions
Step Action
1 From the main menu, select I NTERFACES .
2 Highlight the C ONFIG menu for the DSX interface and press <E NTER >.
3 Right arrow to select F ORMAT and choose ESF or SF.
This F ORMAT
must match the format used by the equipment connected to the
DSX-1 interface. A F ORMAT
mismatch normally results in a Red Alarm
condition.
4 Set the L INE C ODE to B8ZS or AMI.
This line code must match the line code used by the equipment connected to
the DSX-1 interface.
5
Set the E QUALIZATION or line build out. The default setting of 0 D B is usually
sufficient.
6
Set the CSU L PBK option to E NABLE , D ISABLE , or D ISABLE A LL based on
whether looping to this unit from another unit will be allowed.
T1 Interface Setup Instructions (Continued)