ADTRAN 600R - Manual (Page 183)

Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 181
. 2. Configuring the Layer 2 Protocol
For more details on the configuration parameters discussed in this section, refer to the following pages:
Layer 2 ATM Network Interface Protocol menus beginning on page 101
Ethernet Interface Setup Instructions
Most applications should not require a manual setup for the Ethernet interface. By
default, the Ethernet interface is configured to auto-detect the data rate (as either 10
or 100 Mbps). The following steps disable the auto-negotiation parameter and
manually configure the interface.
Step Action
1 From the main menu, select I NTERFACES .
2 Highlight the C ONFIG menu for the ETH interface and press <E NTER >.
3
Use the right arrow to select A UTONEGOTIATION and press <E NTER >. Use the
down arrow to choose OFF.
4 Select the D ATA R ATE field and specify either 10B ASE T or 100B ASE T.
5 Select the D UPLEX T YPE field and specify either H ALF D UPLEX or F ULL D UPLEX .
Layer 2 Protocol (ATM) Configuration – T1 Interface
Step Action
1 From the main menu, select L2 P ROTOCOL and press <E NTER >.
2
Use the arrow keys to select the P ROTOCOL field for the T1 interface. Press
<E NTER >. Select ATM from the list of available protocols.
3
Use the arrow keys to select the C ONFIG menu for the T1 interface and press
<E NTER >.
4 Highlight the ATM C ONFIG menu for the T1 interface and press <E NTER >.
5 Enter the I DLE C ELLS format for your network.
6 Set D ATA S CRAMBLING appropriately for your network.
7
Back all the way out to one level to the PVC C ONFIG menu, and press <E NTER >.
Enter the VPI and VCI values for communicating with that Gateway. Select
R
OUTER under the C ONNECTION field.
8
Select the S ETUP menu and configure the virtual circuit for IP or PPP operation.
(Our example selects IP.) Refer to L2 Protocol (ATM–NET–ATM) > Config >
PVC Config > Setup (Router) on page 103 for more details.