ADTRAN 600R - Manual (Page 56)

Section 4 User Interface Guide Total Access 600 Series System Manual
54 © 2004 ADTRAN, Inc. 61200624L1-1B
S YSTEM C ONFIG > M ANAGEMENT > T ELNET A CCESS > A CTIVE S ESSIONS
Provides a list of all Telnet sessions currently active on the system.
Table 3. Telnet Security Levels
Security Level Description
Full The user has all access to view and configure all menus (same as logging in to the
CRAFT port)
Support The user has read only access to view the S YSTEM I NFO menu. The user has
privileges to view and change everything under the S YSTEM C ONFIG menu except for
the CRAFT port settings, Telnet access lists, and the SNMP management
communities. The user has full access to the S
YSTEM U TILITY menu, including the
ability to upgrade firmware and reset the unit. The user has full access to the
I
NTERFACES , L2 P ROTOCOL , B RIDGE , R OUTER , and DS0 menus. The user does not
have the ability to set R ADIUS S ERVER settings under the S ECURITY menu.
Config The same privileges as support, except that the user does not have privileges to
download firmware or configuration from the S
YSTEM U TILITY menu. The user
additionally does not have the privilege to reset the unit remotely, or enter the terminal
menu.
Router The user has read only privileges for the S YSTEM I NFO menu. There is no access to the
S YSTEM C ONFIG menu. The user has P ING and T RACEROUTE access from the S YSTEM
U TILITY menu. The user is limited to Ethernet configuration and status from the
I NTERFACES menu. The user has full access to the B RIDGE and R OUTER menus.
Access is limited to filters only from the S ECURITY menu.
Voice The user has read only privileges for the S YSTEM I NFO menu. The user has access to
the P ING and T RACEROUTE utilities from the S YSTEM U TILITIES menu. The user has full
access to the FXS module from the I NTERFACES menu.
Status The user has read access of all menus except for the following: S YSTEM
C ONFIG /CRAFT P ORT , S YSTEM C ONFIG /T ELNET A CCESS , S YSTEM C ONFIG /SNMP
M ANAGEMENT , and S ECURITY / R ADIUS S ERVER . The user does not have access to
U PGRADE F IRMWARE , U PGRADE C ONFIG , P ING , or T RACEROUTE menus. The user
cannot reset the unit or enter terminal mode.
#
Displays the index number of the Telnet user.
N AME
Displays the assigned user name.
P ORT
Displays the TCP port used for this Telnet session.
T IME TO L IVE
Displays the amount of time (in minutes) before this Telnet session is terminated, if the user remains
idle.