ADTRAN 600R - Manual (Page 52)

Section 4 User Interface Guide Total Access 600 Series System Manual
50 © 2004 ADTRAN, Inc. 61200624L1-1B
S YSTEM I NFO > P ART N UMBER
(Read only) Displays the ADTRAN-specific part number for the unit.
S
YSTEM
I
NFO
> C
ONTROLLER
S
ERIAL
N
UMBER
(Read only) Displays the ADTRAN-specific part number for the chassis hardware. The serial number of
the unit will automatically display in this field. This serial number matches the serial number located on
the bottom of the unit’s chassis.
S
YSTEM
I
NFO
> S
YSTEM
S
ERIAL
N
UMBER
(Read only) Displays the serial number for the entire system configuration including specific network
interface, FXS specifics, and specialized software, as well as the base chassis. This serial number must be
programmed at ADTRAN and will display dashes (----) for any unit manufactured prior to this serial
number addition.
S YSTEM I NFO > F IRMWARE R EVISION
(Read only) Displays the current firmware revision level of the unit.
S
YSTEM
I
NFO
> B
OOTCODE
R
EVISION
(Read only) Displays the current bootcode revision.
S YSTEM I NFO > S YSTEM U PTIME
Displays the length of time the unit has been running. Each time you reset the system, this value resets to 0
days, 0 hours, 0 min and 0 secs.
S YSTEM I NFO > D ATE /T IME
Displays the current date and time, including seconds. To edit this field, place the cursor on the field and
press
<E NTER > . Then, enter the time in a 24-hour format (such as 23:00:00 for 11:00 pm), and the date in
mm-dd-yyyy format (for example, 05-23-2004). Press <E NTER > when you are finished to accept the
change.
The System Date and Time will reset to 12:00 January 1, 1990 after a system power loss. If
accurate system date and time information is crucial, consider using a time server to
prevent the clock reset.