ADTRAN 600R - Manual (Page 224)

Section 5 DLP-14 Total Access 600 Series System Manual
222 © 2004 ADTRAN, Inc. 61200624L1-1B
Tools and Materials Required
• VT100 compatible terminal or computer with terminal emulation software
• Appropriate cable to connect terminal to the unit (customer-provided)
• DB-9 female to RJ-48 female adapter (ADTRAN proprietary) for connecting to the CRAFT port on the
rear of the unit (see CRAFT Port on page 31).
Upgrade From A.03 to A.03.92 (Transition Build) to A.04
1. Upgrade the firmware from A.03 to A.03.92 (Transition Build) firmware. See DLP-7 (TFTP) or DLP-8
(XMODEM) for instructions on how to perform this upgrade.
2. Once the upgrade to A.03.92 is complete, immediately upgrade the unit to A.04. See
DLP-7 (TFTP) or DLP-8 (XMODEM) for instructions on how to perform this upgrade.
Upgrade From A.03 to A.04 Directly
1. Upgrade the firmware from A.03 to A.04 firmware. See DLP-7 (TFTP) or DLP-8 (XMODEM) for
instructions on how to perform this upgrade.
2. The unit must then be factory defaulted by one of the following methods:
• S elect S YSTEM U TILITY >T ERMINAL M ODE . At the > prompt, type fac. You will then see “Restore Factory
Defaults and Reset Unit? (press 'y').” Press the y key to confirm default. The unit will then
automatically reset.
3. Reconfigure the unit for the specific application.
Perform the steps below in the order listed.
Upgrading from A.03 to A.03.90 (Transition Build) to A.04 will save the unit's
configuration.
Upgrading from A.03 to A.04 directly (or from A.04 to A.03 directly) will erase the unit's
configuration.