ADTRAN 600R - Manual (Page 158)

Section 4 User Interface Guide Total Access 600 Series System Manual
156 © 2004 ADTRAN, Inc. 61200624L1-1B
4. Mapping the DS0s
For more details on the configuration parameters discussed in this section, refer to the following pages:
DS0 Map menus beginning on page 149
Router Options – T1 Interface (L2 Protocol = FRE or PPP)
Step Action
1 From the main menu, select R OUTER and press <E NTER >.
2 Use the right arrow key to highlight C ONFIG and press <E NTER >.
3
Select I NTERFACES and press <E NTER >. Use the right arrow key to highlight the
S ETUP field for the T1 interface and press <E NTER >. Each PVC (frame relay)
on the T1 interface defined in the DLCI M AP has a separate listing in the
R OUTER I NTERFACES table.
4 Set A CTIVE to Y ES to activate the virtual circuit.
5
Select the desired A DDRESS M ODE . Refer to Address Mode on page 122 for
more details.
6
Enter the Total Access 6XX L OCAL IP A DDRESS and corresponding IP
N ETMASK for the selected virtual circuit.
7 Enter the IP address for the next hop router in the F AR -E ND IP A DDRESS field.
8
For NAT configuration, refer to Appendix C. RFC1483 Quick Start (IP Routing
with NAT) on page 179.
9 Left arrow back to the main menu to save the changes.
Router Options – Setting the Default Gateway
Step Action
1 From the main menu, select R OUTER and press <E NTER >.
2 Use the right arrow key to highlight C ONFIG and press <E NTER >.
3
Select R OUTES and press <E NTER >. Set the D EFAULT G ATEWAY field to the
appropriate IP address.
4 Left arrow back to the main menu to save the changes.