ADTRAN 600R - Manual (Page 187)

61200624L1-1B © 2004 ADTRAN, Inc. 185
DLP-1 Connecting a VT100 Terminal or PC to the CRAFT Port
Introduction
Total Access 6XX shelf management and provisioning are facilitated by a series of intuitive menus that are
accessible on a computer screen. Connecting either a VT100 terminal or a PC emulating a VT100 terminal to
the RJ-48
CRAFT port on the rear of the unit allows access to the menus and management features of the
Total Access 6XX. An adapter is required for access to this rear port. For more details concerning this
adapter, refer to CRAFT Port on page 31. This DLP specifies how to connect the VT100 terminal or PC to
the unit.
Prerequisite Procedures
The Total Access 6XX must be powered for terminal communication to function.
Tools and Materials Required
• VT100 compatible terminal or computer with terminal emulation software. A VT100 emulation program
is provided with your shipment as part of the ADTRAN Utilities software suite.
• Appropriate cable to connect terminal to the Total Access 6XX (customer-provided).
• DB-9 female to RJ-48 female adapter (ADTRAN proprietary) for connecting to the CRAFT port on the
rear of the unit (see CRAFT Port on page 31).
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic equipment can be damaged by static electrical discharge. Before handling
modules, put on an antistatic discharge wrist strap to prevent damage to electronic
components. Place equipment in antistatic packing material when transporting or storing.
When working on equipment, always place it on an approved antistatic mat that is
electrically grounded.