ADTRAN 600R - Manual (Page 78)

Section 4 User Interface Guide Total Access 600 Series System Manual
76 © 2004 ADTRAN, Inc. 61200624L1-1B
I NTERFACES (SHDSL) > S TATUS > G. HS E VENT
Internal ADTRAN use only.
I NTERFACES (SHDSL) > S TATUS > G. HS S TATE
Internal ADTRAN use only.
I
NTERFACES
(SHDSL) > S
TATUS
> A
NNEX
Displays the current G.shdsl signaling method as either A NNEX A or A NNEX B .
I NTERFACES (SHDSL) > S TATUS > EOC S TATS
Displays statistics for information transferred between the Total Access 6XX and the DSLAM over the
EOC.
I NTERFACES (SHDSL) > S TATUS > P ERFORMANCE
Displays the current layer one SHDSL information including signal to noise ratio (SNR), errored seconds
(ES), severely errored seconds (SES), unavailable seconds (UAS), and code violations.
I
NTERFACES
(N
ETWORK
SDSL)
View the network SDSL interface status and configure SDSL parameters from this menu. These menus are
only applicable to SDSL Total Access 600 Series systems.
I NTERFACES (SDSL) > C ONFIG
Configure the various SDSL parameters from this menu (such as DSLAM type).
I NTERFACES (SDSL) > C ONFIG > DSLAM
Specify the type of DSLAM the Total Access 6XX SDSL unit is connected to. Choices include: N OKIA
D50 , L UCENT S TINGER
, and C OPPER M OUNTAIN CE150 . DSLAM setup parameters will vary depending on
configured DSLAM type.
I NTERFACES (SDSL) > C ONFIG > DSLAM S ETUP
Configure the DSLAM settings from this menu.
I NTERFACES (SDSL) > C ONFIG > DSLAM S ETUP > T RAINING
Specifies the training method for the SDSL link as either F IXED R ATE
(using only the specified rate) or
F AST EOC (which allows for the fastest negotiated rate).
I NTERFACES (SDSL) > C ONFIG > DSLAM S ETUP > B IT R ATE
Configures the fixed data rate used when training the SDSL link. This menu only applies when the
Training parameter is specified for
F IXED R ATE
. Using a fixed data rate requires the DSLAM to be
configured for the same rate as the Total Access 6XX. Choices vary depending on configured DSLAM and
range from
144K to 2320K .