ADTRAN 600R - Manual (Page 88)

Section 4 User Interface Guide Total Access 600 Series System Manual
86 © 2004 ADTRAN, Inc. 61200624L1-1B
I NTERFACES (FXS) > S TATUS > RA S IG
This parameter displays the status of the Receive A signal bit. The high/low status is indicated by a 0 or 1.
I
NTERFACES
(FXS) > S
TATUS
> RB S
IG
This parameter displays the status of the Receive B signal bit. The high/low status is indicated by a 0 or 1.
I
NTERFACES
(FXS) > T
EST
Activate tests and monitor test status on a per port basis from this menu.
I NTERFACES (FXS) > T EST > P ORT
Displays the port number.
I NTERFACES (FXS) > T EST > T EST
Choices are given below. Default is N ONE
.
I NTERFACES (FXS) > T EST > T EST S TATUS
This option indicates whether a test is in progress.
I
NTERFACES
(FXO)
View the FXO interface status and configure the FXO parameters from this menu.
N ONE Indicates that no test is currently active.
D IGITAL N ETWORK
L PBK
Used to loop back DS0 data coming from the network for each channel.
Received data is latched in on the appropriate receive time slot on the
receive bus. This data is then placed on the transmit bus in the unit’s
transmit time slot.
N ETWORK O N H OOK
T EST
Used to test signaling sent to the network by the unit. On-hook signaling
is sent to the network. The customer loop is forced on-hook while this
test is active.
N ETWORK O FF H OOK
T EST
Used to test signaling sent to the network by the unit. Off-hook signaling
is sent to the network. The customer loop is forced off-hook while this
test is active.
C USTOMER R ING T EST The customer ring test will activate the unit’s ring relay in a
2-on /4-off cadence, providing ringing to the customer loop.
FXO interfaces are only available with Total Access 624 systems.