L2 protocol (tdm firmware) - t1 interface > ppp, L2 protocol (tdm firmware) – t1 interface > ppp, L2 p – ADTRAN 600R User Manual
Page 93: Tdm f, T1 i
Total Access 600 Series System Manual
Section 4 User Interface Guide
61200624L1-1B
© 2004 ADTRAN, Inc.
91
L2 P
ROTOCOL
(TDM F
IRMWARE
) – T1 I
NTERFACE
> PPP
Configure the
L2 P
ROTOCOL
parameters and view the status of the T1 interface using PPP protocol from
this menu.
L2 P
ROTOCOL
(T1 TDM–T1–PPP) > C
ONFIG
Configure the
L2 P
ROTOCOL
parameters for the T1 interface using PPP protocol.
L2 P
ROTOCOL
(TDM–T1–PPP) > C
ONFIG
> M
ODE
Select the
L2 P
ROTOCOL
mode. Choices are
R
OUTE
IP
,
B
RIDGE
A
LL
, and
R
OUTE
IP/B
RIDGE
O
THER
. The
default is
R
OUTE
IP
.
L2 P
ROTOCOL
(TDM–T1–PPP) > C
ONFIG
> A
UTHENTICATION
The
A
UTHENTICATION
menu contains the required parameters for the authentication of the PPP peer and for
being authenticated by the PPP peer. Authentication is applied between the unit and the PPP peer as
described in the Authentication submenus.
L2 P
ROTOCOL
(TDM–T1–PPP) > C
ONFIG
> A
UTHENTICATION
> T
X
M
ETHOD
This parameter specifies how the unit is to be authenticated by the PPP peer. There are four possible
selections. Default is
N
ONE
.
L2 P
ROTOCOL
(TDM–T1–PPP) > C
ONFIG
> PPP
Configure the PPP specific parameters such as
M
AX
C
ONFIG
,
M
AX
T
IMER
,
M
AX
F
AILURE
, and
F
ORCE
P
EER
IP
A
DDRESS
from this menu.
L2 P
ROTOCOL
(TDM–T1–PPP) > C
ONFIG
> PPP > M
AX
C
ONFIG
This value is the number of unanswered configuration-requests that should be transmitted before resetting
PPP negotiations. The possible values are
5
,
10
,
15
and
20
(def).
N
ONE
The connection will not allow the PPP peer to authenticate it
P
AP
, C
HAP
,
OR
E
AP
The unit will ask for
EAP
during the first PPP LCP negotiation and
allow the PPP peer to negotiate down to
CHAP
or
PAP
.
C
HAP
OR
E
AP
The unit will ask for
EAP
during the first PPP LCP negotiation and
allow the PPP peer to negotiate down to
CHAP
but not
PAP
.
E
AP
ONLY
The unit will only allow EAP to be negotiated. If the PPP peer is not
capable of doing EAP, then the connection will not succeed.
P
AP
ONLY
The unit will only allow
PAP
to be negotiated. If the PPP peer is not
capable of doing
PAP
, then the connection will not succeed.