Brocade TurboIron 24X Series Configuration Guide - Manual (Page 1004)

970 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Displaying 802.1X information
Displaying 802.1X configuration information
To display information about the 802.1X configuration on the device, enter the following command.
Syntax: show dot1x
The following table describes the information displayed by the show dot1x command.
TABLE 146 Output from the show dot1x command
This field... Displays...
PAE Capability The Port Access Entity (PAE) role for the device. This is always “Authenticator
Only”.
system-auth-control Whether system authentication control is enabled on the device. The
dot1x-enable command enables system authentication control on the device.
re-authentication Whether periodic re-authentication is enabled on the device. Refer to
“Configuring periodic re-authentication” on page 963.
When periodic re-authentication is enabled, the device automatically
re-authenticates Clients every 3,600 seconds by default.
global-filter-strict-security Whether strict security mode is enabled or disabled globally. Refer to “Disabling
and enabling strict security mode for dynamic filter assignment” on page 959.
quiet-period When the device is unable to authenticate a Client, the amount of time the device
waits before trying again (default 60 seconds).
Refer to
“Setting the quiet period” on page 964 for information on how to change
this setting.
tx-period When a Client does not send back an EAP-response/identity frame, the amount
of time the device waits before retransmitting the EAP-request/identity frame to a
Client (default 30 seconds).
Refer to
“Setting the wait interval for EAP frame retransmissions” on page 964 for
information on how to change this setting.
supp-timeout When a Client does not respond to an EAP-request frame, the amount of time
before the device retransmits the frame.
Refer to
“Setting the wait interval for EAP frame retransmissions” on page 965 for
information on how to change this setting.
server-timeout When the Authentication Server does not respond to a message sent from the
Client, the amount of time before the device retransmits the message.
Refer to
“Specifying a timeout for retransmission of messages to the
authentication server” on page 966 for information on how to change this
setting.
TurboIron#show dot1x
PAE Capability: Authenticator Only
system-auth-control: Enable
re-authentication: Disable
global-filter-strict-security: Enable
quiet-period: 60 Seconds
tx-period: 30 Seconds
supptimeout: 30 Seconds
servertimeout: 30 Seconds
maxreq: 2
re-authperiod: 3600 Seconds
Protocol Version: 1