Displaying software resource usage for vlans – Brocade TurboIron 24X Series Configuration Guide User Manual

Page 820

Advertising
background image

786

Brocade TurboIron 24X Series Configuration Guide

53-1003053-01

IGMP snooping show commands

Displaying software resource usage for VLANs

To display information about the software resources used, enter the following command.

Syntax: show ip multicast resource

The following table describes the output from the show ip multicast resource command.

age

The mcache age. The mcache will be reset to 0 if traffic continues to arrive, otherwise the
mcache will be aged out when it reaches the time defined by the ip multicast mcache-age
command.

uptime

The up time of this mcache in seconds.

vidx

Vidx specifies output port list index. Range is from 4096 to 8191

ref-cnt

The vidx is shared among mcaches having the same output interfaces. Ref-cnt indicates the
number of mcaches using this vidx.

Table 0.7:

This field...

Displays...

alloc

The allocated number of units.

in-use

The number of units which are currently being used.

avail

The number of available units.

get-fail

This displays the number of resource failures.
NOTE: It is important to pay attention to this field.

limit

The upper limit of this expandable field. The limit of multicast group is configured by the
system-max igmp-max-group-addr command. The limit of snoop mcache entry is
configured by the system-max multicast-snoop-mcache command.

get-mem

The number of memory allocation. This number should continue to increase.

size

The size of a unit (in bytes).

init

The initial allocated amount of memory. More memory may be allocated if resources run out.

Available vidx

The output interface (OIF) port mask used by mcache. The entire device has a maximum of
4096 vidx. Different mcaches with the same OIF share the same vidx. If vidx is not available,
the stream cannot be hardware-switched.

Table 0.6:

This field...

Displays...

TurboIron#show ip multicast resource

alloc in-use avail get-fail limit get-mem size init

igmp group 256 1 255 0 32000 1 16 256

igmp phy port 1024 1 1023 0 200000 1 22 1024

…. entries deleted …

snoop mcache entry 128 2 126 0 8192 3 56 128

total pool memory 109056 bytes

has total 2 forwarding hash

VIDX sharing hash : size=2 anchor=997 2nd-hash=no fast-trav=no

Available vidx: 4060. IGMP/MLD use 2

Advertising