Brocade TurboIron 24X Series Configuration Guide - Manual (Page 377)

Brocade TurboIron 24X Series Configuration Guide 343
53-1003053-01
Displaying trunk group configuration information
Enabling sFlow forwarding on a trunk port
You can enable sFlow forwarding on individual ports of a static trunk group. For configuration
details, refer to
“” on page 249.
Setting the sFlow sampling rate on a trunk port
You can configure an individual trunk port to use a different sampling rate than the global default
sampling rate. This feature is supported on static trunk ports.For configuration details, refer to
“Changing the sampling rate for a trunk port” on page 248.
Displaying trunk group configuration information
To display configuration information for the trunk groups, use the show trunk command. This
command displays information for configured trunk groups and operational trunk groups. A
configured trunk group is one that has been configured in the software but has not been placed
into operation by a reset or reboot. An operational trunk group is one that has been placed into
operation by a reset or reboot.
Enter the show trunk command at any CLI level.
Syntax: show trunk [ethernet | pos <portnum> to <portnum>]
NOTE
The show trunk command does not display any form of trunk when links are up.
TurboIron#show trunk
Configured trunks:
Trunk ID: 1
HW Trunk ID: 1
Ports_Configured: 8
Primary Port Monitored: Jointly
Ports 1 2 3 4 5 6 7 8
Port Names none none none none none longna test none
Port_Status enable enable enable enable disable disable enable enable
Monitor on on off on off off off off
Mirror Port 3 4 N/A 5 N/A N/A N/A N/A
Monitor Dir both in N/A out N/A N/A N/A N/A
Operational trunks:
Trunk ID: 1
HW Trunk ID: 1
Duplex: Full
Speed: 1G
Tag: No
Priority: level0
Active Ports: 6
Ports 1 2 3 4 5 6 7 8
Link_Status active active active active down down active active
LACP_Status ready ready ready expired down down ready ready
Load Sharing
Mac Address 3 2 2 2 0 0 6 1
IP 0 0 0 0 0 0 0 0
Multicast 4 2 5 2 0 0 2 3