Local user password changes – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 1116
1082
Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Local user password changes
Local user password changes
Please note that if existing usernames and passwords have been configured on a device with
specific privilege levels (super-user, read-only, port-config), and if you attempt to change a user's
password by executing the following syntax:
Brocade-Device(config)#user fdryreadonly password value
The privilege level of this particular user will be changed from its current value to "super-user". The
“super-user” level username and password combination provides full access to the command line
interface (CLI). To prevent this from occurring, use the following syntax:
Brocade-Device(config)#user fdryreadonly privilege value password
value