Brocade TurboIron 24X Series Configuration Guide - Manual (Page 1095)

Brocade TurboIron 24X Series Configuration Guide 1061
53-1003053-01
Syslog messages
Notification Authentication Enabled on <portnum> The multi-device port authentication feature
was enabled on the on the specified
<portnum>.
Notification BGP Peer <ip-addr> DOWN (IDLE) Indicates that a BGP4 neighbor has gone
down.
The <ip-addr> is the IP address of the
neighbor BGP4 interface with the device.
Notification BGP Peer <ip-addr> UP (ESTABLISHED) Indicates that a BGP4 neighbor has come
up.
The <ip-addr> is the IP address of the
neighbor BGP4 interface with the Brocade
device.
Notification DOT1X issues software but not physical port
down indication of Port <portnum> to other
software applications The device has indicated that the specified
is no longer authorized, but the actual port
may still be active.
Notification DOT1X issues software but not physical port
up indication of Port <portnum> to other
software applications The device has indicated that the specified
port has been authenticated, but the actual
port may not be active.
Notification DOT1X: Port <port_id> Mac <mac_address>
-user <user_id> - RADIUS timeout for
authentication The RADIUS session has timed out for this
802.1x port.
Notification ISIS ENTERED INTO OVERLOAD STATE The Layer 3 Switch has set the overload bit
to on (1), indicating that the Layer 3 Switch
IS-IS resources are overloaded.
Notification ISIS EXITING FROM OVERLOAD STATE The Layer 3 Switch has set the overload bit
to off (0), indicating that the Layer 3 Switch
IS-IS resources are no longer overloaded.
Notification ISIS L1 ADJACENCY DOWN <system-id> on
circuit <circuit-id> The Layer 3 Switch adjacency with this
Level-1 IS has gone down.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
Notification ISIS L1 ADJACENCY UP <system-id> on
circuit <circuit-id> The Layer 3 Switch adjacency with this
Level-1 IS has come up.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
Notification ISIS L2 ADJACENCY DOWN <system-id> on
circuit <circuit-id> The Layer 3 Switch adjacency with this
Level-2 IS has gone down.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
Notification ISIS L2 ADJACENCY UP <system-id> on
circuit <circuit-id> The Layer 3 Switch adjacency with this
Level-2 IS has come up.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
TABLE 176 Brocade Syslog messages (Continued)
Message level Message Explanation