Brocade TurboIron 24X Series Configuration Guide - Manual (Page 187)

Brocade TurboIron 24X Series Configuration Guide 153
53-1003053-01
Displaying global IPv6 information
• The <interface> parameter displays detailed information for a specified interface. For the
interface, you can specify the Ethernet, loopback, tunnel, or VE keywords. If you specify an
Ethernet interface, also specify the port number associated with the interface. If you specify a
loopback, tunnel, or VE interface, also specify the number associated with the interface.
This display shows the following information.
To display detailed information for a specific interface, enter a command such as the following at
any CLI level.
This display shows the following information.
TABLE 32 General IPv6 interface information fields
This field... Displays...
Interface The interface type, and the port number or number of the interface.
Status The status of the interface. The entry in the Status field will be either
“up/up” or “down/down”.
Routing The routing protocols enabled on the interface.
Global Unicast Address The global unicast address of the interface.
TABLE 33 Detailed IPv6 interface information fields
This field... Displays...
Interface/line protocol status The status of interface and line protocol. If you have disabled the
interface with the disable command, the status will be “administratively
down”. Otherwise, the status is either “up” or “down”.
IPv6 status/link-local address The status of IPv6. The status is either “enabled” or “disabled”.
Displays the link-local address, if one is configured for the interface.
Global unicast address(es) Displays the global unicast address(es), if one or more are configured for
the interface.
Joined group address(es) The multicast address(es) that a router interface listens for and
recognizes.
TurboIron#show ipv6 interface ethernet 1
Interface Ethernet 1 is up, line protocol is up
IPv6 is enabled, link-local address is fe80::2e0:52ff:fe99:97
Global unicast address(es):
Joined group address(es):
ff02::9
ff02::1:ff99:9700
ff02::2
ff02::1
MTU is 1500 bytes
ICMP redirects are enabled
ND DAD is enabled, number of DAD attempts: 3
ND reachable time is 30 seconds
ND advertised reachable time is 0 seconds
ND retransmit interval is 1 seconds
ND advertised retransmit interval is 0 seconds