Brocade TurboIron 24X Series Configuration Guide - Manual (Page 453)

Brocade TurboIron 24X Series Configuration Guide 419
53-1003053-01
Displaying VLAN information
Displaying system-wide VLAN information
Use the show vlans command to display VLAN information for all the VLANs configured on the
device.
The following example shows the display output.
Ports that are tagged but are not dual-mode ports are listed as tagged ports. In the following
example display output, ports 7and 8 are dual-mode ports in port-based VLAN 4. Ports 7 and 8
also belong to port-based VLAN 3, but they are tagged ports only in VLAN 3 and are not configured
as dual-mode ports.
TurboIron#show run
Current configuration:
!
ver 07.2.02b071T203
!
!
global-stp
!
trunk ethe 1 to 2
trunk ethe 9 ethe 13
config-trunk-ind
disable ethe 13
!
vlan 202 by port
tagged ethe 5 to 6
router-interface ve 22
!
vlan 203 by port
tagged ethe 5 to 6
router-interface ve 23
!
vlan 204 by port
tagged ethe 5 to 6
router-interface ve 24
!
vlan 205 by port
tagged ethe 5 to 6
router-interface ve 25
!
TurboIron#show vlans
Total PORT-VLAN entries: 2
Maximum PORT-VLAN entries: 8
legend: [S=Slot]
PORT-VLAN 1, Name DEFAULT-VLAN, Priority level0, Spanning tree Off
Untagged Ports: (S2) 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Untagged Ports: (S2) 17 18 19 20 21 22 23 24
Untagged Ports: (S4) 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Untagged Ports: (S4) 17 18 19 20 21 22 23 24
Tagged Ports: None
PORT-VLAN 10, Name IP_VLAN, Priority level0, Spanning tree Off
Untagged Ports: (S1) 1 2 3 4 5 6
Tagged Ports: None