Displaying interface names in syslog messages – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 263
Brocade TurboIron 24X Series Configuration Guide
229
53-1003053-01
Configuring the Syslog service
NOTE
You can specify only one facility. If you configure the device to use two Syslog servers, the device
uses the same facility on both servers.
TurboIron(config)#logging facility local0
Syntax: logging facility <facility-name>
The <facility-name> can be one of the following:
•
kern – kernel messages
•
user – random user-level messages
•
mail – mail system
•
daemon – system daemons
•
auth – security or authorization messages
•
syslog – messages generated internally by Syslog
•
lpr – line printer subsystem
•
news – netnews subsystem
•
uucp – uucp subsystem
•
sys9 – cron/at subsystem
•
sys10 – reserved for system use
•
sys11 – reserved for system use
•
sys12 – reserved for system use
•
sys13 – reserved for system use
•
sys14 – reserved for system use
•
cron – cron/at subsystem
•
local0 – reserved for local use
•
local1 – reserved for local use
•
local2 – reserved for local use
•
local3 – reserved for local use
•
local4 – reserved for local use
•
local5 – reserved for local use
•
local6 – reserved for local use
•
local7 – reserved for local use
Displaying Interface names in Syslog messages
By default, an interface port number are displayed when you display Syslog messages. If you want
to display the name of the interface instead of its number, enter the following command:
TurboIron(config)#ip show-portname
This command is applied globally to all interfaces on Layer 2 Switches and Layer 3 Switches.
Syntax: [no] Ip show-portname