Brocade TurboIron 24X Series Configuration Guide - Manual (Page 443)

Brocade TurboIron 24X Series Configuration Guide 409
53-1003053-01
Configuring 802.1Q-in-Q tagging
TurboIron(config)#tag-type 9100 e 11 to 12
Syntax: [no] tag-type <num> [ethernet <port number> [to <port number>]]
The <num> parameter specifies the tag-type number and can be a hexadecimal value from 0 - ffff.
The default is 8100.
The ethernet <port number> to <port number> parameter specifies the ports that will use the
defined 802.1Q tag. This parameter operates with the following rules:
• If you do not specify a port or range of ports, the 802.1Q tag applies to all Ethernet ports on the
device.
Example configuration
Figure 51 shows an example 802.1Q-in-Q configuration.