Brocade TurboIron 24X Series Configuration Guide - Manual (Page 245)

Brocade TurboIron 24X Series Configuration Guide 211
53-1003053-01
Resetting LLDP statistics
NOTE
The contents of the show output will vary depending on which TLVs are configured to be advertised.
A backslash (\) at the end of a line indicates that the text continues on the next line.
The fields in the below outputs are described in the individual TLV advertisement sections in this
chapter.
Resetting LLDP statistics
To reset LLDP statistics, enter the clear lldp statistics command at the Global CONFIG level of the
CLI. The device will clear the global and per-port LLDP neighbor statistics on the device (refer to
“LLDP statistics” on page 206).
TurboIron#clear lldp statistics
Syntax: clear lldp statistics [ports ethernet <port-list> | all]
If you do not specify any ports or use the keyword all, by default, the system will clear lldp statistics
on all ports.
Clearing cached LLDP neighbor information
The device clears cached LLDP neighbor information after a port becomes disabled and the LLDP
neighbor information ages out. However, if a port is disabled then re-enabled before the neighbor
information ages out, the device will clear the cached LLDP neighbor information when the port is
re-enabled.
If desired, you can manually clear the cache. For example, to clear the cached LLDP neighbor
information for port e 20, enter the following command at the Global CONFIG level of the CLI.
TurboIron#clear lldp neighbors ports e 20
Syntax: clear lldp neighbors [ports ethernet <port-list> | all]
TurboIron#show lldp local-info ports ethernet 28
Local port: 28
+ Chassis ID (MAC address): 0000.0017.50bb
+ Port ID (MAC address): 0000.0017.50d6
+ Time to live: 120 seconds
+ System name : "TX24 Router"
+ Port description : "GigabitEthernet28"
+ System capabilities : bridge, router
Enabled capabilities: bridge, router
+ 802.3 MAC/PHY : auto-negotiation enabled
Advertised capabilities: 10BaseT-HD, 10BaseT-FD, 100BaseTX-HD,
100BaseTX-FD, fdxSPause, fdxBPause, 1000BaseT-HD,
1000BaseT-FD
Operational MAU type : 1000BaseT-FD
+ Link aggregation: not capable
+ Maximum frame size: 1522 octets
+ Port VLAN ID: 4000
+ Management address (IPv4): 10.20.64.246