Brocade TurboIron 24X Series Configuration Guide - Manual (Page 1006)

972 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Displaying 802.1X information
Displaying 802.1X statistics
To display 802.1X statistics for an individual port, enter a command such as the following
Syntax: show dot1x statistics ethernet <portnum>
The <portnum> parameter is a valid port number.
The following table describes the information displayed by the show dot1x statistics command for
an interface.
AdminControlledDirections Indicates whether an unauthorized controlled port exerts control
over communication in both directions (disabling both reception of
incoming frames and transmission of outgoing frames), or just in
the incoming direction (disabling only reception of incoming
frames). On devices, this parameter is set to BOTH.
OperControlledDirections The setting for the OperControlledDirections parameter, as defined
in the 802.1X standard. According to the 802.1X standard, if the
AdminControlledDirections parameter is set to BOTH, the
OperControlledDirections parameter is unconditionally set to BOTH.
Since the AdminControlledDirections parameter on devices is
always set to BOTH, the OperControlledDirections parameter is also
set to BOTH.
AuthControlledPortControl The port control type configured for the interface. If set to auto,
authentication is activated on the 802.1X-enabled interface.
AuthControlledPortStatus The current status of the interface controlled port either authorized
or unauthorized.
multiple-hosts Whether the port is configured to allow multiple Supplicants
accessing the interface on the device through a hub.
Refer to
“Allowing access to multiple hosts” on page 966 for
information on how to change this setting.
TABLE 147 Output from the show dot1x config command for an interface (Continued)
This field... Displays...
TurboIron#show dot1x statistics e 3
Port 3 Statistics:
RX EAPOL Start: 0
RX EAPOL Logoff: 0
RX EAPOL Invalid: 0
RX EAPOL Total: 0
RX EAP Resp/Id: 0
RX EAP Resp other than Resp/Id: 0
RX EAP Length Error: 0
Last EAPOL Version: 0
Last EAPOL Source: 0000.0050.0B83
TX EAPOL Total: 217
TX EAP Req/Id: 163
TX EAP Req other than Req/Id: 0