Canon imagePROGRAF iPF610 - Manual (Page 182)

Handling sheets
Loading heavyweight paper in the Front Paper Feed Slot
Important
• Before loading heavyweight paper, change the media type setting to POP Board. When POP Board is
selected as the type of paper, Front Paper Feed Slot is automatically selected.
Note
• You can load only one sheet of paper at a time.
• Store unused paper in the original package, away from high temperature, humidity, and direct sunlight.
• If the paper is warped, straighten it before loading it.
• Load the paper straight. Loading paper askew will cause an error.
• After loading the paper, you cannot move it laterally to reposition it. Be sure to load the paper straight.
1.
If you send a print job specifying POP Board from a computer beforehand, the type and size of
paper are shown on the Display Screen.Press the Load/Eject button.
Note
• If you will load heavyweight paper before sending a print job, press the Load/Eject button. After a
menu for selection of the type of paper is shown on the Display Screen, press ▲ or ▼ to select POP
Board, and then press the OK button. Next, a menu for selection of the paper size is shown on the
Display Screen. Press ▲ or ▼ to select the size of paper, and then press the OK button.
• For details on types of paper, see the Paper Reference Guide. (→P.112)
• Be sure to select the correct paper type. If this setting does not match the type of paper loaded, it
may cause feed errors and affect the printing quality.
2.
After Leave 70cm/28" space behind printer and press OK. is displayed, check the space
behind the printer and press the OK button.
Note
• Sufcient space behind the printer is required when loading paper in the Front Paper Feed Slot. For
details on the space required for installation, see “Specications”. (→P.74)
3.
Push the knob (a) of the Vertical Paper Guides back to lift the Vertical Paper Guides.
168 Handling Paper