Canon imagePROGRAF iPF610 User Manual
Page 626
Adjusting the feed amount
2.
Press the Menu button to display MAIN MENU.
3.
Press ▲ or ▼ to select Adjust Printer, and then press the ► button.
4.
Press ▲ or ▼ to select Adjust Length, and then press the ► button.
5.
Press ▲ or ▼ to select Yes, and then press the OK button.
A test pattern is printed for adjustment based on the amount of paper stretching or shrinkage.
The scale bar shows “Millimeter” in 50 mm units and “Inch” in 1 inch units.
Note
•
If paper is fed automatically and no roll is loaded, select the media source and click the OK button.
Additionally, when Cassette is selected as the paper source, choose the type and size of paper.
6.
Measure the length of the adjustment pattern. Calculate the difference between the measured
length and actual length. Enter it as a percentage and press the OK button.
You can adjust the value in 0.02% increments. Press ▲ to increase the value and ▼ to decrease
it.
If the scale is printed shorter than actual size, set the value toward the positive side; if it is printed
longer, set the value toward the negative side.
Note
•
You can also specify the adjustment value by selecting Paper Details → Adjust. Setting.
612 Maintenance