Canon imagePROGRAF iPF610 - Manual (Page 715)

Messages regarding paper
Papr Size Mismatch
Cause Corrective Action
If you have selected Fit Roll Paper
Width in the printer driver settings
and Warning in Detect Mismatch
in the printer menu: Printing resumes after the warning
message is displayed. However,
note that this error may cause
paper jams and affect the printing
quality. Try printing again after
adjusting the paper size as
specied in the printer driver and
the size specied on the printer so
that they match.
Follow the steps below to ensure
the paper size matches on the
printer and in the printer driver.
1. Hold down the Stop button for
a second or more to cancel
printing.
2. Load paper of the same size as
you have specied in the printer
driver.
3. Change the paper size in the
printer driver and try printing
again.
The paper size as specied on the
printer does not match the size
specied in the printer driver.
If you have selected Fit Roll Paper
Width in the printer driver settings
and Pause in Detect Mismatch in
the printer menu:
Press the Online button to resume
printing.
However, this may cause a paper
jam or printing problem.
This paper cannot be used.
Check supported paper sizes.
Cause Corrective Action
The loaded paper is too large for the printer. Load paper of the correct size.
(→P.117)
The loaded paper is too small for the printer. Load paper of the correct size.
(→P.117)
Paper has been loaded that is too small to print
the test pattern for printhead adjustment or nozzle
checking. Load unused paper A4/Letter-sized or larger. More
than one sheet may be required depending on the
adjustment.
Error Message 701