Canon imagePROGRAF iPF610 - Manual (Page 727)

Messages regarding printing or adjusment
Messages regarding printing or adjusment
Use another paper.
Cause Corrective Action
For automatic Printhead adjustment, we recommend
using a type of paper that you often use, other than
lm.
(→P.599) The Printhead and feed amount cannot be adjusted
when highly transparent lm is loaded.
Adjust the feed amount manually.
(→P.607)
Cannot print as specied.
Press Load/Eject and replace paper with A4/LTR (vertical) or larger
Cause Corrective Action
The loaded paper is too small. Press the Load/Eject button and switch to paper A4/Letter,
vertical, or larger.
Press Load/Eject and replace roll with 10 in. wide or larger roll.
Cause Corrective Action
The loaded paper is too small. Press the Load/Eject button and load a roll at least 10
inches (254 mm) wide.
Cannot adjust band.
Cause Corrective Action
The Printhead nozzles are clogged. Follow the steps below to check the nozzles.
1. Print a test pattern to check the nozzles.
(→P.625)
2. Clean the Printhead if the nozzles are clogged.
(→P.626)
Highly transparent lm is loaded that cannot be used
for feed amount adjustment. Adjust the feed amount manually.
(→P.607)
Cannot adjust printhead.
Cause Corrective Action
The Printhead nozzles are clogged. Follow the steps below to check the nozzles.
1. Print a test pattern to check the nozzles.
(→P.625)
2. Clean the Printhead if the nozzles are clogged.
(→P.626)
Highly transparent lm is loaded that cannot be used
for Printhead adjustment. We recommend using a type of paper that you often
use, other than lm, for Printhead adjustment.
(→P.599)
Error Message 713