HP Color LaserJet CM4730 Multifunction Printer series - Manual (Page 112)

4. Load media into the tray face up.
NOTE For best performance, fill the tray completely without splitting the ream of paper.
Splitting the ream can cause a multifeed problem. The capacity of the paper tray can vary.
For example, if you are using 75 g/m
2 (20 lb) paper, the tray holds a full ream of 500 sheets.
If the media is heavier, the tray will not hold a full ream. Do not overfill the tray.
NOTE If the tray is not adjusted correctly, an error message might appear or the media
might jam.
5. Slide the tray into the MFP. The MFP control panel shows the tray’s media type and size. If the
configuration is not correct, touch
OK on the control panel. If the configuration is correct, touch
Exit .
Loading undetectable standard-sized media into tray 2, 3, and 4
The following undetectable standard-sized media is supported in the 500-sheet trays:
● Executive (JIS)
● 8.5 x 13
● Double Japan postcard
● 16K
96 Chapter 7 Paper and print media ENWW