Stapler/stacker – HP Color LaserJet CM4730 Multifunction Printer series User Manual
Page 314
The 3-bin mailbox has three operating modes:
●
Mailbox mode. The bins can be assigned to a user or to a group of users. All print, copy, and fax
jobs that an assigned user or group of users sends are delivered to the designated bin. Each user
can select the bin in the printer driver or at the control panel.
When the designated bin is full, the MFP stops printing. Printing continues only when you empty
the bin.
●
Stacker mode. The 3-bin mailbox can combine the bins to act as a stacker. It can stack up to
700 sheets of 75 g/m
2
(20 lb bond) paper. Jobs are sent to the bottom bin first, then to the middle
bin, and then to the top bin. Print jobs that require more than 500 sheets fill the bottom bin and
continue stacking into the middle and top bins.
When all three bins are full, the MFP stops printing. Printing continues only when you remove paper
from the top bin. The MFP does not resume printing if you remove paper from the bottom bin or
the middle bin before you remove paper from the top bin.
When the 3-bin mailbox is in stacker mode, you cannot designate that a job be sent to a particular
bin.
NOTE
Do not remove paper from the top bin and then attempt to put it in place again. This
causes the pages to stack in the incorrect order.
●
Function-separator mode. You can configure the bins to receive jobs that come from a specific
MFP function, such as printed jobs, copy jobs, or faxes. For instance, you can specify that all copy
jobs are sent to the top bin.
The MFP stops functioning when the designated bin is full. Printing, copying, or faxing can continue
only when you empty the bin.
See
for information on configuring and using the optional 3–bin mailbox.
Stapler/stacker
The optional stapler/stacker provides automatic stapling and stacking functionality for printed or copied
jobs. See
for information on configuring and using the optional stapler/stacker.
298 Appendix A Supplies and accessories
ENWW