HP Color LaserJet CM4730 Multifunction Printer series User Manual
Page 253
Control panel message
Description
Recommended action
Replace Supplies - Using black
A color supply (or supplies) has reached the
out condition and the Color Supply Out
menu item is set to Autocontinue black.
No user input is required for printing to
continue. Printing continues in black.
Replace Transfer Kit
The transfer unit is at end of life. Printing can
continue, but print quality might be reduced.
Replace the transfer kit.
1.
Open the right-side covers.
2.
Lower the transfer unit by pulling
downward on the green handle at the
top of the unit.
3.
Depress the small blue latches located
on either side of the bottom of the
transfer unit and lift the unit out of the
MFP.
4.
Install the new transfer unit.
5.
Close the right-side covers.
Rotating <color> Motor
A component test is in progress; the
component selected is the <color> cartridge
motor.
Press Stop when ready to stop this test.
Rotating Motor - To exit press STOP
The MFP is executing a component test and
the component selected is a motor.
Press Stop when ready to stop this test.
SANITIZING DISK <X>% COMPLETE Do
not power off
The hard disk is being cleaned.
Contact the network administrator.
SCAN FAILURE Press 'Start' to rescan
The scan was unsuccessful and the
document needs to be rescanned.
If necessary, reposition the document to
rescan it, and then press
Start
.
Size mismatch in tray XX
The media in the listed tray does not match
the size specified for that tray.
1.
Load the correct media.
2.
If the message persists, contact HP
Support at
SMTP Gateway
The SMTP gateway has exceeded a time out
value.
Verify the e-mail server address. Contact the
network administrator.
The Digital Sending Service at <IP
Address> does not service this MFP.
Contact administrator.
The MFP cannot communicate with the
specified IP address.
Verify the IP address. Contact the network
administrator.
The Digital Sending Service must be
upgraded to support this version of the
MFP firmware. Contact administrator.
The Digital Sending Service is not supported
by the version of the firmware that is currently
installed for the MFP.
Check the firmware version. Contact the
network administrator.
The folder you have entered is not a valid
folder.
The folder name was entered incorrectly, or
the folder does not exist.
Re-enter the folder name correctly, or add the
folder.
There might be a document on the glass.
If there is, remove it, then press “Start”.
A digital send or copy job has been performed
from the scanner glass, but the original
document needs to be removed.
Remove the original document from the
scanner glass and press
Start
.
TOO MANY PAGES IN JOB TO STAPLE
The maximum number of sheets the stapler
can staple is 30.
For print jobs that have more than 30 pages,
staple them manually.
Type Mismatch In Tray <XX>
The specified tray contains a media type that
does not match the configured type.
The specified tray will not be used until this
condition is addressed. Printing can continue
from other trays.
Table 16-1
Control-panel messages (continued)
ENWW
Control-panel messages 237