Initial setup menu, Networking and i/o – HP Color LaserJet CM4730 Multifunction Printer series User Manual

Page 47

Advertising
background image

Initial Setup menu

Administration

>

Initial Setup

The

Initial Setup

menu contains the sub-menus shown:

Networking and I/O

menu

Fax Setup

menu

E-mail Setup

menu

NOTE

Values shown with "(default)" are the factory-default values. Some menu items have no

default.

Networking and I/O

Administration

>

Initial Setup

>

Networking and I/O

Table 2-10

Networking and I/O

Menu item

Sub-menu item

Values

Description

I/O Timeout

Select a value in the
range. The factory default
setting is 15 seconds.

I/O timeout refers to the elapsed time before a print job
fails. If the stream of data that the device receives for
a print job gets interrupted, this setting indicates how
long the device will wait before it reports that the job
has failed.

Parallel Input

NOTE

This

item appears
only if an EIO
accessory is
installed.

High Speed

No

Yes

(default)

Use the

High Speed

setting to configure the speed that

the parallel port uses to communicate with the host.

Advanced Functions

Enabled

(default)

Disabled

Use the

Advanced Functions

setting to enable or

disable bidirectional parallel communication.

Embedded Jetdirect

See

Table 2-11 Jetdirect menus

for the list of options.

EIO <X> Jetdirect

Table 2-11

Jetdirect menus

Menu item

Sub-menu item

Sub-menu item

Values and Description

TCP/IP

Enable

Off

: Disable the TCP/IP protocol.

On

(default): Enable the TCP/IP protocol.

Host Name

An alphanumeric string, up to 32 characters, used to
identify the device. This name is listed on the
HP Jetdirect configuration page. The default host name
is NPIxxxxxx, where xxxxxx is the last six digits of the
LAN hardware (MAC) address.

IPV4 Settings

Config Method

Specifies the method that TCP/IPv4 parameters will be
configured on the HP Jetdirect print server.

ENWW

Initial Setup menu

31

Advertising