Allied Telesis AT-S63 - Manual (Page 149)

AT-S63 Management Software Web Browser User’s Guide
Section II: Advanced Operations 149
Modifying an Access Control List
To modify an access control list, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Network Security option.
3. Select the ACL tab.
The ACL tab is shown in Figure 45 on page 146.
4. Select the ACL to be modified and click Modify.
The Modify ACLs page is displayed, as shown in Figure 47.
Figure 47. Modify ACLs Page
5. Configure the parameters as needed. For definitions of the
parameters, refer to “Configuring an Access Control List” on page 146.
6. Click Apply.
Changes to the ACL are immediately implemented on the switch.
7. To permanently save your changes, select the Save Config option in
the Configuration menu.