Allied Telesis AT-S63 - Manual (Page 54)

Chapter 2: Port Parameters
54 Section I: Basic Operations
Resetting a Port to the Default Settings
To reset a port to the default settings, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration menu, select the Layer 1 option.
The Layer 1 page is displayed with the Port Settings tab selected by
default, as shown in Figure 6 on page 42.
3. In the switch image, click a port to be returned to the default settings.
The selected port turns white. You can reset more than one port at a
time. (To deselect a port, click it again.)
4. Click Modify. To configure all of the ports, click Modify All.
The Port Configuration page is displayed, as shown Figure 7 on page
43.
5. Click Defaults.
The port(s) are returned to the default settings.