Allied Telesis AT-S63 - Manual (Page 402)

Chapter 27: Management Access Control List
402 Section VII: Management Security
Modifying an ACE
To modify an ACE, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Mgmt. Security option.
3. Select the Mgmt. ACL tab.
The tab is shown in Figure 164 on page 398.
4. Select the ACE to be modified from the Management ACL List section
in the tab and click Modify.
The Modify MACL page is shown in Figure 166.
Figure 166. Modify MACL Page
5. Change the parameters in the Add New MACL page, as necessary.
For parameter definitions, refer to “Creating an ACE” on page 400.
The ID number of an entry cannot be changed.
6. Click Apply.
The changes are immediately activated on the ACE.
7. If desired, repeat Steps 4 to 6 to modify more ACEs.
8. To permanently save your changes, select the Save Config option in
the Configuration menu.