Enabling or disabling gvrp on a port – Allied Telesis AT-S63 User Manual
Page 332
Chapter 21: GARP VLAN Registration Protocol
332
Section V: Virtual LANs
Enabling or Disabling GVRP on a Port
To enable or disable GVRP on a port, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Layer 2 option.
3. Select the GVRP tab.
The GVRP tab is shown in Figure 132 on page 330.
4. In the GVRP Port Configuration section, click the ports to be to
configured.
5. Click Modify.
The GVRP Port Configuration page is shown in Figure 133.
Figure 133. GVRP Port Configuration Page
6. Click Normal to have the port propagate GVRP information, or None
to prevent processing GVRP information and transmitting PDUs.
7. Click Apply to activate the change, or Cancel to cancel.
8. To permanently save your changes, select the Save Config option in
the Configuration menu.