Allied Telesis AT-S63 - Manual (Page 289)

AT-S63 Management Software Web Browser User’s Guide
Section IV: Spanning Tree Protocols 289
Edge-Port
Whether or not the port is operating as an edge port. The possible
settings are Yes and No.
Point-to-Point
Whether or not the port is functioning as a point-to-point port. The
possible settings are Yes, No, and Auto Detect.
Cost
Port cost of the port. The default is Auto Update.
Priority
The number used as a tie-breaker when two or more ports have equal
costs to the root bridge.
6. Click OK to close the page.
Resetting RSTP
to the Default
Settings
To reset RSTP to the default settings, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration menu, select Layer 2.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 109 on page 272.
4. Verify that there is no check in the Enable Spanning Tree check box.
If there is a check, click the option to remove it. Spanning tree must be
disabled in order for you to return it to its default settings.
5. Click Configure.
The Configure RSTP Bridge Parameters tab is shown in Figure 115 on
page 283.
6. Click Defaults.
The RSTP settings are returned to their default values.
7. To permanently save your changes, select the Save Config option in
the Configuration menu.