Allied Telesis AT-S63 - Manual (Page 249)

AT-S63 Management Software Web Browser User’s Guide
Section III: SNMPv3 249
6. To permanently save your changes, select the Save Config option in
the Configuration menu.
Modifying a
Target
Parameters Table
Entry
To modify an entry in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 1 on page 26.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 75 on page 204.
3. In the SNMPv3 section, click the button next to Configure Target
Parameters Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Parameters Table tab is shown in Figure 94 on
page 245.
4. Click the button next to the Target Parameters Table entry to be
changed, and then click Modify.
The Modify SNMPv3 Target Parameter page is shown in Figure 96 on
page 249.
Figure 96. Modify SNMPv3 Target Parameter Page