Allied Telesis AT-S63 - Manual (Page 94)

Chapter 7: Port Mirroring
94 Section I: Basic Features
Creating a Port Mirror
To create a port mirror, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Layer 1 option.
3. Select the Port Mirroring tab.
The Port Mirroring tab is shown in Figure 26.
Figure 26. Port Mirroring Tab (Configuration)
The tab displays a table with the following columns:
Mirror to Port
Specifies the destination port of the mirrored traffic. There can be only
one destination port. If this column contains a 0 (zero), there is no port
mirror.
Ingress Ports
Specifies the ports whose ingress traffic is to be mirrored to the
destination port.
Egress Ports
Specifies the ports whose egress traffic is to be mirrored to the
destination port.
Status
Specifies the status of the port mirror as either enabled or disabled.