Allied Telesis AT-S63 - Manual (Page 233)

AT-S63 Management Software Web Browser User’s Guide
Section III: SNMPv3 233
Configuring the SNMPv3 Notify Table
You can create, delete, and modify an SNMPv3 Notify Table entry. See
the following procedures:
ˆ “Creating a Notify Table Entry” on page 233
ˆ “Deleting a Notify Table Entry” on page 235
ˆ “Modifying a Notify Table Entry” on page 236
For reference information about the SNMPv3 Notify Table, see Chapter
21, “SNMPv3” in the AT-S63 Management Software Menus Interface
User’s Guide.
Creating a Notify
Table Entry
To create an entry in the SNMPv3 Notify Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 1 on page 26.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 75 on page 204.
3. In the SNMPv3 section, click the button next to Configure Notify
Table, and then click Configure at the bottom of the tab.