Allied Telesis AT-S63 - Manual (Page 302)

Chapter 19: Multiple Spanning Tree Protocol
302 Section IV: Spanning Tree Protocols
Configuring MSTP Port Parameters
To configure MSTP port parameters, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Layer 2 option.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 120 on page 292.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 121 on
page 295.
5. In the diagram of the switch at the bottom of the MSTP Spanning Tree
Expanded page, click the port to be configured. You can configure
more than one port at a time.
6. Click Modify.
The MSTP Settings - Port(s) page is shown in Figure 124.
Figure 124. MSTP Settings - Port(s) Page
7. Configure the following parameters as necessary.
The port parameters can be divided into two groups: generic
parameters and MSTI-specific parameters. A generic port parameter is
set just once on a port and applies to all of a port’s MSTIs
assignments. Generic parameters are:
ˆ External path cost