Adaptec ANA-62000 - Manual (Page 139)

11-3
Duralink64 Port Aggregation for NetWare
Installing the NetWare Port Aggregation
Driver
If you are installing NetWare 4.x on a new server, do not add the
DuraLAN NIC at this time. When prompted to add the NIC, select
No
, and then continue with the NetWare installation.
If you are installing NetWare 5.0 on a new server, please see Install of
Duralink64 Driver during NetWare 5.0 Operating System Installation on
page 9-3.
Note: This driver uses 32 receive buffers for each port.
Therefore, if you are using multiple ports, the number of
receive buffers must be increased.
Type load edit c:\nwserver\startup.ncf, and then insert the
following commands at the end of the file:
SET MINIMUM PACKET RECEIVE BUFFERS = 512
SET MAXIMUM PACKET RECEIVE BUFFERS = 1024
To install the Port Aggregation driver for NetWare follow these
steps:
1 Insert the Duralink64 Driver for NetWare 4.x/5.0 diskette.
2 At the system prompt, type: a:\nwserver\setupsf
3 Press Enter. The Select Driver window appears.
Figure 11-1. The Select Driver Window
4 Select Port Aggregation/FEC and press Enter.
5 In the message indicating the New Adaptec NICs have been
detected, press Enter.
6 Continue to Configuring Ports on page 11-4.