Maximal force latch – RADWAG WPW 60/H5/K Multifunctional Scales User Manual
Page 101
Advertising
Caution:
Users can use this function in other work modes like counting pieces,
weighing in percents etc. Only values and units can change.
24.4. Maximal force latch
Procedure:
• Enter
the
TOP work mode:
• TOP selection is signalled by the Max pictogram in the upper
line of the display:
• When a force acting on the pan changes on the display only
the maximal value can be seen,
• Remove the acting force,
• Press before the next measurement.
Return to weighing:
See 11.3.
24.5. Deviation in percents in relation to a standard mass
Software can help to control deviations (in %) from a standard (nominal)
mass. The standard mass can be settled by weighings or inscribing.
- 101 -
Advertising
This manual is related to the following products: