Point in mass form in ean-13 code, Automatic correction of accuracy – RADWAG WPW 60/H5/K Multifunctional Scales User Manual
Page 118
24.8.7. Point in mass form in EAN-13 code
In common systems of retail EAN13 bar codes are used. The sellers use
weights that shows mass in kilos with 3 places after dot accuracy. There
are 5 places in the mass code. That makes impossible to use weights with
100 and more kilos range (2 places after dot is approved only). In these
cases the bar code is not printed. The balance cannot relate mass to
required standards in the codes. Parameter <P7.5.7 EAN POINT. POS.>
is optional and changes place of the dot in the mass form in EAN13 code.
Notice:
Please remember that changing the mass form in EAN13 code can cause
wrong reception by external systems. Sometimes the external systems
expects that the dot is on the 3
rd
place in the mass form.
Procedure:
• Enter parameters group <P7 WORK MODES> following
step 11.2. of the manual and then:
Return to weighing:
See ch. 11.3 - return to weighing.
24.8.8. Automatic Correction of Accuracy
The function of Automatic Correction of Accuracy can be used
for correction of unit mass (SMP). In order to enable the function:
- 118 -