RADWAG WPW 60/H5/K Multifunctional Scales - Manual (Page 105)

• You will see a set of dashes on the display <- - - - - - - - - - ->
showing the progress of weighing during the time set in
<P7.3.1 WEIGH. TIME> - (see 24.6.1),
• After the procedure of weighing is completed the result will be latched,
• Additionally you will hear a short “beep” sound and see Hold
pictogram in the left part of the display:
• Before initiating the next weighings press
key,
• Weighing procedure can be terminated while in progress
by pressing .
Return to weighing:
See 11.3.
24.7. Dosing
Standard indicators are equipped with signalling fields and internal circuit
of - 3 optoinsulated inputs (5
÷24V DC), 3 optoinsulated reed relay outputs.
Caution:
1. Working mode „Dosing” does not support continuous printouts;
2. Inductive loads connected to the dosing indicator should have
protections against the coil induction phenomenon. Example
connetion diagrams of dosing indicators outputs with direct and
alternative current protections are in point 32.6 of the manual.
24.7.1. Dosing mode setting
Users can chose one of three different modes <P7.4.1 DOSING NAM.>.
Procedure:
• Enter
<P7 WORK MODES> and then:
- 105 -