RADWAG WPT/8B 300C Ramps Bed Scales - Manual (Page 20)

- 20 -
•
Place a weighed baby / infant on scale’s weighing platform (baby
scale)
•
Stand on scale’s weighing platform (personal scale)
•
Sit on the chair (of a chair scale)
•
Lie on the bed (bed scale)
After a few seconds, after measurement stabilization, it is possible to read
the result.
Caution:
A. Baby scale is designed to weighing infants in lying position. If it is
used to weight infants / babies in sitting position, pay special
attention to place the infant / baby in the center of weighing platform.
In other case, the weighing platform may rest on the protective
bumpers, thus causing incorrect and unreliable measurement
results.
B. While weighing babies in sitting position pay special attention that
the baby does not loose balance and falls off the weighing platform.
C. Tarring is impossible if the display indicates negative or zero mass
value. In such case the scale signals an error message Err3 and
emits a short beep sound.
12.2. Manual tare insertion
The sale enables manual determining of tare value.
While in weighing mode:
• Simultaneously press
and keys
• The display indicates the following: