RADWAG WPT/8B 300C Ramps Bed Scales - Manual (Page 61)

- 61 -
Table 206
Recommended minimal distance between portable devices for RFI
communication and the DEVICE
The DEVICE intended to operate in the electromagnetic environment, where electromagnetic
disturbances of RF are under control. Recipient or user of the DEVICE can prevent
electromagnetic interference by keeping minimal distances between portable devices for
wireless communication (transmitters) and the DEVICE prompted below, according to
maximal output power of communication devices.
Given maximal
transmitter’s
power
[W]
Minimal distance adequate for the transmitter frequencies
[m]
150 kHz to 80 MHz
d = 1,2√P
80 MHz to 800 MHz
d = 1,2√P
800 MHz to 2,5 GHz
d = 2,3√P
0,01 0,12 0,12 0,23
0,1 0,38 0,38 0,73
1 1,2 1,2 2,3
10 3,8 3,8 7,3
100 12 12 23
For transmitters with the maximal output power not mentioned above, the advisable minimal
distance d in meters can be estimated by equation adequate to the frequency of the
transmitter, where P is a rated maximal power in watts (W).
CAUTION 1: If f= 80MHz and f=800MHz higher frequency range is taken.
CAUTION 2: Given information are not applicable in every situation. Propagation of
electromagnetic waves is influenced by absorption and reflection from surfaces, objects and
persons..
RF – frequency from the interval o electromagnetic spectrum which is between the lower
range of radio frequencies of long waves and the infrared range; frequencies useful for radio
transmission. Limit frequencies are 9 kHz and 3 000 GHz
CAUTION! Operating cellular telephones (in the proximity
of 2.8 m) can cause unstable operation of the DEVICE.
CAUTION! Operation in the proximity of (e.g. 1 m) devices
for microwave therapy or shortwave therapy can cause
unstable operation of the DEVICE.
CAUTION! Using accessories and cables other than
described in present manual may result in increased
emission of electromagnetic waves and decreased wear
resistance of the DEVICE.