Avaya 555-233-116 - Manual (Page 103)

Paradyne COMSPHERE 3910
Issue 4 October 2002 103 555-233-116
Creating an editable configuration set
It is generally easiest to configure the modem by starting from the default, factory
configuration. You then change only those settings that are different for a
DEFINITY installation.
Copying factory default settings
Make a copy of the default, factory configuration using the following procedure.
1. On the front panel of the COMSPHERE 3910, press the F2 button to select
Configure.
The Ld EditArea frm > prompt appears.
2. Press the right-arrow button four times.
The Factory menu item appears.
3. Press the F1 button to select Factory.
The Ld Fact Preset: > prompt appears.
4. Press the right-arrow button.
5. Press F2 to select Async_Dial.
6. Press F3 to select Save.
The Sav EditArea to > prompt appears.
7. Press F1 to save configuration changes to the Active(Saved) storage
area.
Since you are changing the active area to a new set of options— Factory/
Async_Dial—the modem automatically runs a power-on self-test. The
Idle:19.2 and Status Configure messages appear.
8. To return to the top-level menu at any time, press the double up-arrow
button.
Loading the copied default settings
Load the default settings so that you can edit them for use with CMS. Proceed as
follows.
1. On the front panel of the COMSPHERE 3910, press F2 to select
Configure.
The Ld EditArea frm > prompt appears.
2. Press the right-arrow button once.
The Active(Saved) prompt appears.
3. Press F1 to select Choose Function.
4. Press F1 to select Edit.
The Edit StrapGroup > prompt appears.