Avaya 555-233-116 - Manual (Page 215)

Multimedia call handling (MMCH)
Issue 4 October 2002 215 555-233-116
Configuring the PictureTel
PCS50 (Live 50) and PCS100
These endpoints do not need any special configuration settings. The standard
PictureTel configuration is as follows:
1. Load the LiveShare Plus software first.
2. Enter the user name and company name. Use default values for
subsequent prompts.
3. Enter a site name.
4. Select Restart Windows and FINISH.
5. Load the Live 50 VAFC drivers.
6. Load the Picture Tel Live 50 software.
7. Open the PictureTel Live program group from the Windows ™ Program
Manager screen.
8. Double click on the PictureTel Live Configure icon.
9. At the Welcome screen, click on continue.
10. Go to the registration confirmation screen and click on continue.
11. Enter the Network Interface Settings. Be sure that “ISDN” has an “x” in
the box. Click on continue.
12. At the ISDN Parameters screen, set the signaling protocol to USA
Canada: 5ESS Custom Point-to-Point. Click on continue.
13. At the Hardware Settings screen, set the following: Interrupt (IRQ) to 11,
Base I/O Port=280, and Base Memory=D000. Under the Video Input
section, select the NTSC circle. Click on continue.
14. At the Audio Device screen, enter the necessary information.
15. At the Node Name screen, enter a name for the PC using the application
software package.
Table 25. Minimum system requirements
Version: Live 50 version 1.7 or higher
Minimum Processor Speed: 487/33 MHz, DX2/77
Disk Space: 20 MB
Memory: 8 MB RAM, 17 MB recommended
ISA Expansion Slots (17-bit): 2 slots
Monitor: VGA, SVGA
Operating System: Windows ™ 3.1x or Windows ™ 95