Avaya 555-233-116 - Manual (Page 124)

Terminal server installation
555-233-116 124 Issue 4 October 2002
Follow these typical steps:
NOTE:
Depending on the adjunct’s connections, you may not need all of these
pieces.
1. Connect the null modem adapter to COM1 port on the adjunct.
NOTE:
The null modem is an important element in this setup. Without it, data may
not transfer correctly.
2. Connect the other end of the null modem adapter to the DB25 to RJ45
cable.
3. Connect the RJ45 end to any port on the IOLAN+.
Administering the IOLAN+
To administer the IOLAN+ the first time, you must connect a PC or laptop to the
RS232 Port 1 on the IOLAN+ terminal server. Follow these typical steps:
NOTE:
Depending on the computer’s COM port, you may not need all of these
pieces.
1. Connect the DB9 end of the DB9-to-DB25 cable to the COM port on the PC
or laptop.
2. Connect the DB25 end to the null modem adapter.
3. Connect the other end of the null modem adapter to the DB25 to RJ45
cable.
4. Connect the RJ45 end to Port 1 of the IOLAN+.
Before beginning the initial administration, make sure you have the following
information:
■
New IP address and subnet mask for IOLAN+
■
Host name for IOLAN+
■
IP address of C-LAN Ethernet interface
■
Port number of C-LAN Ethernet interface where adjunct connects.